Set of leveling clips LEVEL SYSTEM T-HOLD 1mm, 200pcs

Leveling clamp set LEVEL SYSTEM T-HOLD 1mm, 200pcs SIXTOL

A set of high-quality leveling clamps LEVEL SYSTEM T-HOLD for leveling tiles and wall coverings. These clamps are used in combination with leveling wedges and pliers during the laying of floor tiles - you insert the clamps into the joints according to the width of the joint, insert the wedge into the clamp and use special leveling pliers to level the floor tiles or wall coverings. Once the adhesive under the tiles has hardened, use a rubber mallet to knock the clamps down, fill the joints and you're done. The wedges, pliers and mallet are not part of this set and must be purchased separately as needed.

Main advantages:

• Easy, fast and precise laying of tiles and paving stones
• Eliminates height differences between tiles and paving stones, so-called lippage
• Suitable for tiles and paving stones of all materials and shapes

Usage:

• 1. During laying, insert clips with a width according to the desired joint width into the joints between the tiles or paving stones.
• 2. Insert wedges into all clips.
• 3. Use the leveling pliers to pull the first wedge into the clip until the tiles are level.
• 4. Screw the fixing screw on the pliers according to the first wedge to pull the rest of the paving stones or paving stones with the same force.
• 5. Tighten the rest of the wedges.
• 6. After the adhesive has set (usually after 24 hours), remove the clips by striking them with a rubber mallet from the side in the direction of the joint.
• Note: The wedges can be used repeatedly.
• Note: The joint must be clean to properly remove the clips with a mallet.

Package contents:

• 200 x Leveling clips 1 mm

Technical parameters:

• Thickness: 1 mm
• Width: 36 mm
• Height: 40 mm
• Material: plastic
• For tiles/tiles with a thickness of: 4 - 15 mm