Set of leveling clips LEVEL SYSTEM T-HOLD 3mm, 500 pcs

Set of leveling clips LEVEL SYSTEM T-HOLD 3mm, 500 pcs SIXTOL

A set of quality leveling clips LEVEL SYSTEM T-HOLD for aligning floor and wall tiles. These clips are used in combination with leveling wedges and pliers during tile installation to achieve a level surface - insert the clips into the joints according to the joint width, slide the wedge into the clip and using special leveling pliers level the floor or wall tiles to the same plane. Once the adhesive under the tiles has hardened, remove the clips by striking them with a rubber mallet, finish the joints and you're done. Wedges, pliers, and mallet are not included in this set and should be purchased separately if needed.

Main advantages:

• Easy, quick and accurate installation of wall and floor tiles
• Eliminates height differences between wall and floor tiles, the so-called lippage
• Suitable for tiles and wall coverings of all materials and shapes

Usage:

• 1. During installation, insert clips into the joints between tiles according to the required joint width.
• 2. Insert wedges into all clips.
• 3. Using the leveling pliers, pull the first wedge into the clip until the tiles are level.
• 4. Using the first wedge as a reference, tighten the locking screw on the pliers so that the rest of the tiles are pulled with the same force.
• 5. Tighten the remaining wedges.
• 6. After the adhesive has hardened (typically after 24 hours) remove the clips by striking them from the side with a rubber mallet in the direction of the joint.
• Note: Wedges can be reused.
• Note: For proper removal of the clips with a mallet, the joint must be clean.

Package contents:

• 500 x Leveling clips 3 mm

Technical specifications:

• Thickness: 3 mm
• Width: 36 mm
• Height: 40 mm
• Material: plastic
• For tiles thickness: 4 - 15 mm